Author Topic: Checking FET's and IGBT's (Read 9080 times)

gox · « **on:** March 07, 2009, 08:10:18 pm »

How can i check for dead fets and igbt's with multimeter?

Tnx

MWfire · « **Reply #1 on:** March 07, 2009, 09:10:07 pm »

Measure resistance between drain and source(2. and 3. pin). If fet is good, than resistance is high(more than 1Mohm).

gox · « **Reply #2 on:** March 07, 2009, 09:36:58 pm »

Tnx

i`ll chek it up and replace the dead ones

Does this counts for IGBT's too?

MWfire · « **Reply #3 on:** March 07, 2009, 10:18:58 pm »

z0tya · « **Reply #4 on:** March 20, 2009, 09:08:03 pm »

Can I test the output pin of igbt with dvm or led with serial resistor?

rob@vems.co.uk · « **Reply #5 on:** March 20, 2009, 09:21:20 pm »

I use an LED driven from the +5V supply into the IGBT.

News: