Does the boost switch work in this firmware?
When Boost alternate settings enabled..
I´ve got this on a bench and making air temp colder makes boost target higher....
I can´t find anything that suggest a connection between the two?
This is closed loop setup
Analog input works to lower maximum allowed DutyCycle as expected.
TPS voltage also changes duty cycle by using the Boost vs. TPS scaling as expected.
Open loop boost, open loop DC adjustment channel enabled
If the DC is 10% in the map, maximum possible is 20% duty cycle and minimum is 0%
If map is 20% , max is 40% duty and minimum 9% duty
if map is 30% then max is 60% duty and min 14%.
and so on, everything above 50% in the map allows for 100% max via the switch,
if DC adjustment channel disabled, then DC is same as the DC map.
If Alternate settings disabled.
DC changes to chase the boost target.
but air temp also contributes to the boost target.
But lowers the boost target, that is if target is MAP-target.
If "boost target" then DC is always 0%
Why is MAT making such a mess of things?
If MAT goes above 30C then boost target is lower then 100kpa
