« previous next »
Pages: [1]

Author Topic: CA18DET RPM Settings in Megatune  (Read 7034 times)

Offline liquidsmoke

  • Jr. Member
  • **
  • Posts: 3
  • BHP: 1
CA18DET RPM Settings in Megatune
« on: May 02, 2008, 11:18:29 am »
Anyone know what the RPM input settings should be for a CA18DET in Megatune used with VEMS WBO2 sensor?

I used to have it working fine, but forgotten what settings i used now!
Logged

Offline rob@vems.co.uk

  • Hero Member
  • *****
  • Posts: 3115
  • BHP: 49
    • VEMS Forum
Re: CA18DET RPM Settings in Megatune
« Reply #1 on: May 02, 2008, 07:36:04 pm »
IIRC you used the standard settings (what ever they were!)

You might like to try: http://www.vems.us/eaw-52_firmware.php

Rob
Logged

Offline liquidsmoke

  • Jr. Member
  • **
  • Posts: 3
  • BHP: 1
Re: CA18DET RPM Settings in Megatune
« Reply #2 on: May 04, 2008, 05:20:10 pm »
Cheers - yeah i was being a muppet and i changed the baud rate to 9600 instead of the 19200 it defaults to. Works fine now :)

regarding this firmware. If it's working fine with my setup is there any benefits from upgrading? The only gripe i have currently is that on occasion the rev readings shoot up and there ends up a few spikes in the curve. no biggie though...
Logged

Offline rob@vems.co.uk

  • Hero Member
  • *****
  • Posts: 3115
  • BHP: 49
    • VEMS Forum
Re: CA18DET RPM Settings in Megatune
« Reply #3 on: May 04, 2008, 05:46:10 pm »
If you're happy with what you have then theres no real point in upgrading - I'm not sure if the spikes in the datalogs bit has been cured or not.
Logged
Pages: [1]
« previous next »