Author Topic: Engine Now runs, see pg 2  (Read 20825 times)

Offline rob@vems.co.uk

  • Hero Member
  • *****
  • Posts: 3115
  • BHP: 49
    • VEMS Forum
Re: Engine Now runs, see pg 2
« Reply #30 on: May 09, 2008, 05:54:52 am »
The MAP sensor was calibrated using the local weather station's pressure readings.

TonyC: Only dnb knows why the injectors are ordered like that - for as long as they're batch fired order doesnt really matter much.

Offline Tony C

  • Hero Member
  • *****
  • Posts: 650
  • BHP: 8
    • Capriracing
Re: Engine Now runs, see pg 2
« Reply #31 on: May 09, 2008, 06:01:45 am »
ok no worries,
was just curious that was all, as tried stus injector outputs on my vems and mine refused to run.

Vems Ecu, Twin Plenum efi and N2o
13.314 @ 104.39 mph (10/06/07 3.9 v8)
Sponsored by: www.caprisport.com & www.interpart.biz
Web site: http://www.capriracing.co.uk

Vems Firmware: V1.1.74

Offline dnb

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 837
  • BHP: 19
Re: Engine Now runs, see pg 2
« Reply #32 on: May 09, 2008, 02:37:40 pm »
I did answer the injector question in my last post - but I have no idea why your car should decide to not run with those settings!!

Offline Stuball

  • Jr. Member
  • **
  • Posts: 25
  • BHP: 1
Re: Engine Now runs, see pg 2
« Reply #33 on: May 11, 2008, 07:43:38 pm »
Well car is all up and running now.

Tony has helped a lot getting it roughly setup etc.  Did a 200 mile round trip today and it seemed quite happy.

We are having one problem though

We re-did the ve table to start at 5kpa instead of 30.  We burnt this to the ECU.  The problem is that if i then open up megatune and turn on the ECU, the ve table still starts at 30kpa?? It doesnt seem to save the new table..

STU

Offline Stuball

  • Jr. Member
  • **
  • Posts: 25
  • BHP: 1
Re: Engine Now runs, see pg 2
« Reply #34 on: May 11, 2008, 08:45:35 pm »
Disregard the above,  sorted it now