OK thanks will try that
but I still have problems with my trigger
I have a triggerwheel with 2 teeth 180° apart.
Its two 8mm bolts (the thread of it).
If I put them too close to the sensor it hits and misfires,if I put it a very very very bit furhter away it doesn't read (triggererrors) the trigger anymore
I tried to put the bolts on the thread in order to have a bigger triggersurface but then there is absolutely no trigger anymore?
?
Can someone check my trigger parameters please?
Primary trigger =3
Edge= Rising
Type=coiltype
the rest is disabled
TDC after trigger=61
Number of teeth on wheel=2
Crank min period=1200
Angular width of tooth=0
Tooth relation normal=118
Tooth relation missing=181
Angular width of missing tooth=0
Engine phase when to reset=255
Thanks