Has anyone seen lambda readings in a log file, but no ego correction happening?

[Tony C]

ah rite no probs mate,.
i gather the laptop needs to be conected to the ecu and powered up before you do the generate feature yeah?

[rob@vems.co.uk]

No you can generate configs and tables off line.

[Tony C]

ah mine came up error when i tried that
came up on the screen load s of warinings that could not be found,
and then said do not use config.mtt think that what it said
i'll try again now

[Tony C]

http://www.v-8.org.uk/ecu/config.zip
i have the config that mine comes up with here Rob/anyone.

[Tony C]

HELP!,
god knows how,
but i have managed to click on generate-config 12x12 with WB defaults,
and now it says this below if you click the correct generate-config 12x12 feature:

warning: table t has less than 8 items
Geometry check failed, reported the error:
table 1 contains too many rows, it should have no more than table k has columns.
MakeConfig v0.5<c>2005 VEMS Project. Rob Humpris.

config.mtt generated with 0 errors and 0 warnings.
press any key to continue...

what have i done and how can we get it back to the original setup?

[rob@vems.co.uk]

You've done nothing wrong and nothings broken, all that this means is that you have got a table thats causing a problem.
The generate-config takes the config.txt and tables.txt and converts them to config.mtt and tables.mtt the originals are undamaged.

What version of software do you have running on the VEMS on your car?

[Tony C]

nt sure off hand mate,
i think we loaded 1.0.73

[rob@vems.co.uk]

could you email me the config.txt and tables.txt.

The firmware version is shown in the top bar of MegaTune when its running.

[Tony C]

all mine says is megatune 2.25
that the one?
the config and tables .txt files are in the config folder yeah Rob?

[Tony C]

if so, the config.txt file is ok,
but the tables one is a blank,
i have found some table.txt that you have done when you were testing the VEMS at your place,

[Tony C]

right renamed the tables file that was stored on when you had the ecu mate,
to tables,
then did the gen config 12x12 and no errors came up thsi time,#

that sound ok?
or you want me to mail the config and tables one over to double check?

when you do the config upload .bat is it the config and tables .mtt files that it uploads? if so you want them too?

[rob@vems.co.uk]

Yes, mail them here and I'll check them over.

[Tony C]

mail sent mate,
anything else you need?
all this just to change one value from 6 to 7

[Tony C]

Rob just editted the config,
with the value ego_conf from 06 to 07 and now
when you run gen conf, it does all the errors again,
load the original that i saved as a copy and it's fine,
any ideas mate?

[Tony C]

just opened the config i edited, and all the values are bunched up in a continuous line,
im going through and seperating it as it was originally listed, to see if that works,
will report back after moving the values to match the copied version, BUT with the ego conf changed,