« previous next »
Pages: [1]

Author Topic: Wiring Shift cut input(ground) to EC18-8  (Read 4770 times)

Offline jdm ej1 95

  • Jr. Member
  • **
  • Posts: 7
  • BHP: 2
Wiring Shift cut input(ground) to EC18-8
« on: October 17, 2015, 12:14:56 am »
Can i use this input as my shift cut input.   its my only one left with pullup and protection.

labeled as wheel speed on my spec sheet.
Logged

Offline VEMS

  • Administrator
  • Sr. Member
  • *****
  • Posts: 487
  • BHP: 22
Re: Wiring Shift cut input(ground) to EC18-8
« Reply #1 on: October 17, 2015, 08:34:11 am »
Hello Jdm ej1 95,

No, wheelspeed input cannot be used as shiftcut input.

Best regards, Dave
Logged

Offline jdm ej1 95

  • Jr. Member
  • **
  • Posts: 7
  • BHP: 2
Re: Wiring Shift cut input(ground) to EC18-8
« Reply #2 on: October 24, 2015, 12:43:52 am »
is protection a necessity when wiring a ground trigger to the pullup?
Logged
Pages: [1]
« previous next »