« previous next »
Pages: [1]

Author Topic: Testing IGBTs  (Read 8851 times)

Offline paul_f

  • Full Member
  • ***
  • Posts: 120
  • BHP: 8
Testing IGBTs
« on: March 26, 2012, 02:39:17 pm »
Is there anyway to test the IGBTs without opening the ECU.?

My bus has no sparks after winter (engine has been cranked occasionally with fuel pump relay removed)

I am wondering whether I have blown them in the cold weather with probably low battery voltage.

There is 12v at the coil pack, so it is not a blown fuse

Cheers
Paul
Logged

Offline GintsK

  • Hero Member
  • *****
  • Posts: 1257
  • BHP: 50
Re: Testing IGBTs
« Reply #1 on: March 26, 2012, 08:14:14 pm »
Yes. Remove all coils. Invert ignition outputs under Ignition Settings. Now at each coil plug you should have close to supply voltage. Test current flow capability with halogen bulb. Do not forget return to normal output polarity!

Also You can try to ignite coils with test feature.

Gints
Logged

Offline paul_f

  • Full Member
  • ***
  • Posts: 120
  • BHP: 8
Re: Testing IGBTs
« Reply #2 on: March 26, 2012, 10:24:15 pm »
Thanks Gints, I will give that a go tomorrow
Logged

Offline paul_f

  • Full Member
  • ***
  • Posts: 120
  • BHP: 8
Re: Testing IGBTs
« Reply #3 on: March 27, 2012, 09:11:58 am »
Well I don't get 12V on them when inverted.

I have taken the board out and they don't look burnt.  I will take them out of circuit and see how I can test them.
Logged

Offline paul_f

  • Full Member
  • ***
  • Posts: 120
  • BHP: 8
Re: Testing IGBTs
« Reply #4 on: March 27, 2012, 01:06:23 pm »
I remembered I had some spare in the rescue kit.

I have just compared them and they seem to measure identically with the DVM ???

I'll change them and then have another look
Logged

Offline mattias

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 1075
  • BHP: 41
    • Sävar Turbo Site
Re: Testing IGBTs
« Reply #5 on: March 27, 2012, 04:14:27 pm »
Quote from: paul_f on March 27, 2012, 09:11:58 am
Well I don't get 12V on them when inverted.
Please describe how you verified this. It's impossible to measure voltage at the IGBT output pin, it's ground.

Logged

Offline paul_f

  • Full Member
  • ***
  • Posts: 120
  • BHP: 8
Re: Testing IGBTs
« Reply #6 on: March 27, 2012, 09:26:53 pm »
Yes I realised that when I opened the ECU in the lab at work and realised there was nothing wrong with the IGBTs...

In fact I had upgraded to 1.1.95 in November but had not started it.  I think it was the Safety mode at fault, but it was strange - there was definately fuel getting through as it back fired.

Anyway it now starts after upgrading to 1.1.96 ;D

Thanks for the help.  Now I just have to find out why the EGT has stopped working ???
Logged
Pages: [1]
« previous next »