IAC Lock in VemsTune

[Ascona 400]

I noticed that there is a menu option under the "Tools" menu called "IAC Lock", is this function implemented?
If so, i guess it basically does the same thing as the "mdi.." command?

I'm trying to figure out why my IAC won't work, I've verified the wiring (with a diode), tried all possible settings and tried with a different IAC-valve.
And nothing seams to do any difference, the IAC-valve won't move a bit.. Unfortunately I don't have any oscilloscope..

I'm starting to run out of ideas 

[multiplex]

it does in fact work, as i used it last night 

i'm running 1.1.69 firmware.

its only active when the menu is up. As in, if you make a setting and close the window it no longer forces the output

only odd thing is it works from 0-255, whereas the PWM settings work 0-100.  So the values don't always translate over to idle settings.

maybe set it to 255 and see if you get voltage on your pins?

Otherwise move to another output?

[Ascona 400]

Perfect!
Thanks for clarifying that the function works!

I'll try to set different values and see if the voltage changes over the IAC.
An oscilloscope had been nice in this case..


 

[SPatrickB]

I have fixed all trigger problems and now have my engine "running" but idle is ~2500 RPM, so I'm looking at IAC to get this down.

So, I can remove my IAC from the throttle body and manipulate the lock to see it move (if it can)? Correct?

[gunni]

Yes.

You can do the same via max and min on in the PWM control, but this is easier. I guess a slider control would be the ideal quick movement tester.