« previous next »
Pages: [1]

Author Topic: Error in Windows when trying to open Megatune  (Read 7235 times)

Offline Turbos10

  • Jr. Member
  • **
  • Posts: 6
  • BHP: 2
Error in Windows when trying to open Megatune
« on: April 05, 2010, 07:48:16 am »
All,

I am trying to open Megatune and continue to get an error in windows that just says "megatune efi tuning has encountered a problem and must close".  It will not open at all.  PC has windows XP.

Anyone help with this??

Thanks!
Logged

Offline gunni

  • Hero Member
  • *****
  • Posts: 1492
  • BHP: 37
Re: Error in Windows when trying to open Megatune
« Reply #1 on: April 05, 2010, 07:40:47 pm »
What version are you trying to open?

Maybe try re installing that version?
Logged

Offline rob@vems.co.uk

  • Hero Member
  • *****
  • Posts: 3115
  • BHP: 49
    • VEMS Forum
Re: Error in Windows when trying to open Megatune
« Reply #2 on: April 05, 2010, 10:40:04 pm »
If you are starting with a fresh install you may be better off using VEMSTune
Logged

Offline dnb

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 837
  • BHP: 19
Re: Error in Windows when trying to open Megatune
« Reply #3 on: April 07, 2010, 03:57:26 am »
This is usually because you have the AIM dash output via the serial port on the ECU enabled. 

If you connect the VEMS to the laptop, load MT and then power up the ECU it should work and you can disable AIM.  It should all be fine then.
Logged
Pages: [1]
« previous next »