Profiles - High / Standard Boost

[multiplex]

I'm a little confused regarding high / standard boost profile settings. I was under the impression this was directly related to how the firmware was compiled?

also how is the kpa unit different than the map sensor range?

i think i'm overthinking these settings and getting myself in trouble with a firmware upgrade 

thanks.

[rob@vems.co.uk]

Its not firmware related, but depending on your choice of Table kPa unit, if you've gone for a 400kpa sensor you'll have selected 2 (high boost) and you'll want the High Boost profile. We have this because high boost needs to scale its pressure readings differently to the lowboost.

[Pet]

Its not firmware related, but depending on your choice of Table kPa unit, if you've gone for a 400kpa sensor you'll have selected 2 (high boost) and you'll want the High Boost profile. We have this because high boost needs to scale its pressure readings differently to the lowboost.

Hi, a little bit outdated topic, but anyway.... If I want to use the 300kPa sensor from VEMS shop (5V supply voltage, 300 kPa), what should I do ?
FW 1.0.78RC2.

Thansk. Pet

[rob@vems.co.uk]

Use the Highboost option and set Settings->Basic Settings MAP Sensor range (kPa) to 300