« previous next »
Pages: [1]

Author Topic: Impreza newagde Vems frontplate  (Read 6492 times)

Offline Denmark

  • Hero Member
  • *****
  • Posts: 542
  • BHP: 7
Impreza newagde Vems frontplate
« on: September 16, 2008, 09:18:49 pm »
I have just made this, for the weekends Vems challenge ;)





This is for a bugeye WRX..



/Skassa
« Last Edit: October 11, 2008, 05:43:50 pm by Denmark »
Logged
working on the boxer

Offline Denmark

  • Hero Member
  • *****
  • Posts: 542
  • BHP: 7
Re: Impreza newagde Vems frontplate
« Reply #1 on: September 17, 2008, 08:23:44 pm »
And then.. :)

« Last Edit: October 11, 2008, 05:45:32 pm by Denmark »
Logged
working on the boxer

Offline gunni

  • Hero Member
  • *****
  • Posts: 1492
  • BHP: 37
Re: Impreza newagde Vems frontplate
« Reply #2 on: September 18, 2008, 12:37:54 pm »
What does the wiring look on the inside?
Logged

Offline Denmark

  • Hero Member
  • *****
  • Posts: 542
  • BHP: 7
Re: Impreza newagde Vems frontplate
« Reply #3 on: September 18, 2008, 12:58:38 pm »
The Wiring is just made as short as possible, and then it goes to the print, like the Vems AMP connector would have done..
The wires is then glued, when the print is all tested in the car


I will take a pic when i have made the final wires,


/Skassa
Logged
working on the boxer

Offline Denmark

  • Hero Member
  • *****
  • Posts: 542
  • BHP: 7
Re: Impreza newagde Vems frontplate
« Reply #4 on: October 11, 2008, 05:42:06 pm »
this is before the hotmelt





Just another impreza Vems made, going in a car tomorrow :)


/Skassa
« Last Edit: October 11, 2008, 05:44:33 pm by Denmark »
Logged
working on the boxer
Pages: [1]
« previous next »