« previous next »
Pages: [1]

Author Topic: 1.2.10 Issues  (Read 7229 times)

Offline billman

  • Full Member
  • ***
  • Posts: 223
  • BHP: 2
1.2.10 Issues
« on: February 26, 2013, 10:51:36 am »
I started a new thread here in order to see If other experience the same.

I updated to 1.2.10 and noticed the following:

When choosing the Divby9 settings from the dropdown menu on Primary Trigger settings something occurs I think and the config goes bad.

I did a manual Divby9 Setup and it works without issues.

But I noticed the following: With 1.1.96 TDC before trigger was 59 (Divby3). with 1.2.10 and Divby3 I had to set it at 56 and now with Divby9 I had to set it at 53! Why is that?
Logged

Offline GintsK

  • Hero Member
  • *****
  • Posts: 1257
  • BHP: 50
Re: 1.2.10 Issues
« Reply #1 on: February 27, 2013, 06:01:00 am »
Yesterday I tried div by 9 on fresh installation. And got even 51deg. But angle was stable, and everything else what I test worked OK.
« Last Edit: February 27, 2013, 06:03:07 am by GintsK »
Logged

Offline billman

  • Full Member
  • ***
  • Posts: 223
  • BHP: 2
Re: 1.2.10 Issues
« Reply #2 on: February 27, 2013, 07:19:23 am »
Did you choose the Divby9 settings from the drop-down menu or did you used another previous config that was on Divby9?
Logged

Offline GintsK

  • Hero Member
  • *****
  • Posts: 1257
  • BHP: 50
Re: 1.2.10 Issues
« Reply #3 on: February 27, 2013, 06:32:41 pm »
From dropdown. But then adopted to my IGn table. And maybe "RPM filter, cam based trigger" was active.
Logged

Offline billman

  • Full Member
  • ***
  • Posts: 223
  • BHP: 2
Re: 1.2.10 Issues
« Reply #4 on: February 27, 2013, 10:14:59 pm »
I tried twice from the dropdown menu to change from Divby3 to divby9 and both times I had issues.  I am curious to find out why that happened.

Did you noticed less trigger errors with the 1.2.x versions?

I noticed the car starts up much quicker. Less cranking time.
Logged
Pages: [1]
« previous next »