« previous next »
Pages: [1]

Author Topic: question about grounding RS232  (Read 5543 times)

Offline rossi46numberone

  • Full Member
  • ***
  • Posts: 125
  • BHP: 4
question about grounding RS232
« on: August 04, 2011, 01:51:17 am »
Hi,
I have read in an other topic that the EC18-pin 17 is internally grounding for convenience.
Does this output can be use for grounding the RS232;or is better to go EC36-pin 26?

Michele....
Logged

Offline gunni

  • Hero Member
  • *****
  • Posts: 1492
  • BHP: 37
Re: question about grounding RS232
« Reply #1 on: August 04, 2011, 08:47:36 pm »
measure if it connects to EC36-25 the sensor ground, if so then its fine
Logged

Offline mattias

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 1075
  • BHP: 41
    • Sävar Turbo Site
Re: question about grounding RS232
« Reply #2 on: August 08, 2011, 11:40:51 am »
If you have a knock chip, but not using it, then you can use the knock signal ground as RS-232 (serial port) ground.
Logged

Offline boostd audi

  • Full Member
  • ***
  • Posts: 207
  • BHP: 9
    • vems.live
Re: question about grounding RS232
« Reply #3 on: August 09, 2011, 04:07:27 pm »
it should ground to pin 26 not 25  ;)

typo
Logged
boost addict's Vems powered Audi VRT s2
Pages: [1]
« previous next »