custom sensor curve- VDO sensor for trans oil temp

[nmerrill]

I'm trying to input trans oil temp to VEMS using a VDO 323 058 sensor.  I have the calibration curve.
It seems like the "custom sensor curve" ohm/volt values are fixed.
This sensor looks like this:
temp F  Ohms
120   322.8
160   135
180   105.7
200   76
220   57
240   42
260   31
280   23
300   18.6

How do I edit the custom sensor curve values to fit?
Thanks

[nmerrill]

Am I correct that the analog input calibration wizard only works for liner response sensors?

[nmerrill]

I've seen references to files that can be uploaded to vemstune - is this where I need to focus?

[Kamuto]

I'm trying to input trans oil temp to VEMS using a VDO 323 058 sensor.  I have the calibration curve.
It seems like the "custom sensor curve" ohm/volt values are fixed.
This sensor looks like this:
temp F  Ohms
120   322.8
160   135
180   105.7
200   76
220   57
240   42
260   31
280   23
300   18.6

How do I edit the custom sensor curve values to fit?
Thanks

ohms of the sensor means nothing, it all depends in the input pullup if you want properly calibrate sensor, put it in water, put thermometer there raise water temp and adjust readings accordingly..

[nmerrill]

Ok, I can test the sensor, sure.  How many points are good?
But, the main issue is - can the values in the custom sensor table be altered?

[Kamuto]

Ok, I can test the sensor, sure.  How many points are good?
But, the main issue is - can the values in the custom sensor table be altered?

yes, you have to change temp values there ) and it's in celsius not bullshit F