Author Topic: Testing outputs for 3x2 coil  (Read 6843 times)

Offline gox

  • Full Member
  • ***
  • Posts: 198
  • BHP: 6
Testing outputs for 3x2 coil
« on: May 25, 2008, 03:52:28 pm »
There is 4pin connector,4 for +Vbatt and 3 pins for coils.
Problems is that i`m not shure if pin1 is for 1st 2 coils,how do i test ignition outputs on vems,i know that command is something like mdh...
I want to test the pins to know what pin fires which coils...
E30 2.7 - VEMS,KKK K27.2,Schrick,1bar

Offline dnb

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 837
  • BHP: 19
Re: Testing outputs for 3x2 coil
« Reply #1 on: May 28, 2008, 12:09:02 am »
The command is mdnXX where XX is 00, 01, 02 etc.

Be aware that the XX represents the position h[2] table, so you need to populate this first.