« previous next »
Pages: [1]

Author Topic: VEMS internals  (Read 6129 times)

Offline gunni

  • Hero Member
  • *****
  • Posts: 1492
  • BHP: 37
VEMS internals
« on: January 18, 2008, 02:40:48 pm »
I´m finishing one and need to know if I need to use 1.5K Diodes on the grounding wires.
The pre assembled ones have them but it doesn´t show in the assembly information.

One is the flyback on the top side while the other is on the bottom side
onto what seems to be a grounding point both connect to pin 36.
Gunni
« Last Edit: January 18, 2008, 03:03:14 pm by gunni »
Logged

Offline rob@vems.co.uk

  • Hero Member
  • *****
  • Posts: 3115
  • BHP: 49
    • VEMS Forum
Re: VEMS internals
« Reply #1 on: January 18, 2008, 04:44:06 pm »
I'll ask.

Are you sure that these arent the flyback diodes?
Logged

Offline gunni

  • Hero Member
  • *****
  • Posts: 1492
  • BHP: 37
Re: VEMS internals
« Reply #2 on: January 18, 2008, 05:10:13 pm »
They are.  :P

I´m sourcing some at the moment to finish this ecu.
then I can get going in installing it.
Logged

Offline rob@vems.co.uk

  • Hero Member
  • *****
  • Posts: 3115
  • BHP: 49
    • VEMS Forum
Re: VEMS internals
« Reply #3 on: January 18, 2008, 09:23:41 pm »
Question asked - I'll report back any findings.
Logged

Offline gunni

  • Hero Member
  • *****
  • Posts: 1492
  • BHP: 37
Re: VEMS internals
« Reply #4 on: January 20, 2008, 03:45:16 pm »
Well I installed the diodes. finished the communications cable which is a headphone jack connectors converted into serial on one end
and ec18 pins on the other.

I´m "getting" vems alot better now.
I got the unit some fresh firmware and connected it using megatune and there are already some tables and stuff in it.
which is funny,. I checked the tables.txt after the download scribt and there was nothing, I must have used a default.bat file.

All is good, now I can finally get started on what I know already and thats harness wiring.
Logged
Pages: [1]
« previous next »