Has anyone seen lambda readings in a log file, but no ego correction happening?

[Tony C]

ta mate i was getting meself a bit confussed :D

[jago]

right i'm off to tony's tomorrow morning to have a look at this ego problem, and to fit the diode.

Tony's said about reflashing the ecu. do you have the files tony???

also any pointers on the ego thing wiring wise and setting wise?

[Tony C]

Right, not reflashed the ecu as we want to make sure the config file is right first,
David or anyone not sure if you can see a problem within it,
http://www.v-8.org.uk/zipfiles/config.txt

on another note:
added the diode today and fired the ole gal up on the new 440cc injectors,
man she does arf rev a lot quicker and crisper now.

just need to sort a few things out so i can run you a datalog off Dave,
the injector openings etc can't be changed until you have looked at the datalog yeah Dave?

[multiplex]

i just started to have this problem =(

was working fine forever, but then this weekend i set my correction values to zero.. after some tuning i set them back - but no correction is happening.

this was such a great feature! hopefully its something stupid

[[email protected]]

What firmware version are you running?  I'll see if this can be replicated.  It might point towards an answer for you both.

Rob

[Tony C]

that would be handy if it is something that can be corrected,

[[email protected]]

Just looking through published configs and it seems that Tony has:
ego_conf=06

and most of the published ones have:
ego_conf=07

Which is the only significance that I can see.

[multiplex]

i'll check mine after work. i have a good copy of my config before this weekend.

i'm running firmware 1.1.26

[Tony C]

would that stop my ego from working Rob?

[[email protected]]

It could be the thing causing the problem, and wont hurt to try it.

[Tony C]

just edit the saved config then upload it back to the ecu yeah?

[Tony C]

how does the rest of the config compare mate?

[[email protected]]

yeah, save, generate and upload.

I didnt dig much deeper than the ego stuff in the config, theres so much in there to be getting on with!

[Tony C]

no worries mate.
i.ll do that later this week,
why do you have to use generate mate???
cant you just edit the downloaded config, save it then use the upload-config bat? to upload it back to the ecu?

[[email protected]]

The config is designed to be close to human editable as possible, but to upload it to the unit it needs to be made VEMS readable which is what the generate-config does, it turns the likes of:
primep=00
primep_temp_scaling=00
cwl=28
cwh=14
cranking_thres=03
awev=41
awev_temp_scaling=0F
awec=C0
to
Mantt
g00c00
g01c00
g02c96
g03c5A
g04c05
g05c41
g06c0F
g07cC0