Old Vems Update

[Kindinos89]

Good day to all of you guys... Recently a friend bought a Citroen Saxo turbo running a dp-engineering PNP ECU... I know at some point this was a topic in here as I have searched the forum....I have emailed dp-engineering and there was no response yet...(8 days and counting)....The car was in version 1.0.72 which was not in the web library... I updated the firmware 1.0.75 so I could use VEMStune... Now for my questions:  If I update to 1.19. something before the new bootloader will I need to check my harness pinout??? The second question: Do I need to use an AVR ISP cable to flash the new boot loader and go to the newer firmware... educated guess the ECU is dated before 2010... As I saw the newer firmware is much much better from what I saw... and my final request if someone can share the stock sensors calibrations for the TU5J4 1.6 motor...


Best Regards and many thanks
George

[Kamuto]

hi, probably you would need isp cable and probably you will need to write email to vems requesting bootloader upgrade

[k33emo]

Morning did you have any success updating to he newer firmware ?