new to vems. failing at first hurdle

[Hutchie]

i have been running my car on a link ecu, but to cut a long story short it is borrowed. so i purchased a vems ecu.
and so far i just cant get the laptop, using serial on back not a usb converter, to talk to the vems box.

how do i know what version of software i need to talk to the vems.
how do i know what firmware is on vems if i cant talk to it.
and how do you upload new firmware??

thanks in advance
Hutchie

[gunni]

Have a read through this page.

http://www.vems.hu/wiki/index.php?page=MembersPage%2FPhatBob%2FUserGuide

[Hutchie]

thanks but i have already read that, and printed it so i can follow it @ car, i simply cannot get the laptop to see the vems

[gunni]

Are you 100% sure you have.

12v and ground at the vems.
correct serial connection
correctly selected COM port?

[max]

Also try to set higher serial data rate. I couldnt get mine to work until I changed this to 19200. FW 1.1.53

[Hutchie]

i have tried all the different speeds, but i have no idea what firm ware i have

definately have power and very good ground

:S

[[email protected]]

Where abouts are you?

[Hutchie]

im in the north east of england, i bought this vems off mini-valver (dave) you may know him

[[email protected]]

That ECU should have firmware v1.0.73 on it.  You may have problems with newer versions trying to connect.
http://media.vems.se/code/VemsMT1.0.73Final.zip

[Hutchie]

tried that  :'(

[[email protected]]

Have you tried swapping the tx and rx wires into the ec18 plug?

[Hutchie]

i thought it was plugged into that plug???

[paul_f]

Did you make the harness?

Or are you plugging into the LCD connector?

[Hutchie]

the harness came with it

[[email protected]]

Now that is really strange - the cable is a straight through pin 2 to pin 2 and pin 3 to pin 3 isnt it?