Print Page - Calibration of EGT and WBO2 sensor

Title: Calibration of EGT and WBO2 sensor
Post by: g60luke on August 18, 2009, 08:47:51 PM

Hi,

Just finished fitting the guage and sensors, great product and quality ;)

Do I need to calibrate the sensors.

If so, how?! ;D

Cheers
Luke

Title: Re: Calibration of EGT and WBO2 sensor
Post by: [email protected] on August 18, 2009, 09:23:29 PM

No calibration of the wideband is needed, I think the EGT is calibrated and may just need a little fine tuning. I normally use ice and boiling water to check ~0^oC and ~100^oC

Title: Re: Calibration of EGT and WBO2 sensor
Post by: g60luke on August 18, 2009, 09:33:35 PM

Thanks for the quick response :)

I am mostly concerned with the AFR reading being accurate. So out of the box its just a case of plug and play for this to be accurate..?

I have installed it and driven the car and the readings seem sensible, but wanted to check before I start to adjust my boost/fuelling!

Cheers
Luke

Title: Re: Calibration of EGT and WBO2 sensor
Post by: [email protected] on August 19, 2009, 04:38:08 AM

With EGT 1degree accuracy isn't quite so important. I know that they bought a natty new calibration tool, although deciphering what they do with it is an exercise in itself. Thats why if its pretty good between 0 and 100 I tend to be happy.

VEMS Community Forum

Technical => Wideband & EGT Gauge => Topic started by: g60luke on August 18, 2009, 08:47:51 PM