Print Page - N2O Input Switch Channel Settings

Title: N2O Input Switch Channel Settings
Post by: Sprocket on August 03, 2009, 03:16:24 AM

Firmware 1.0.79

N2O settings

input switch channel number is a decimal number, just to confuse us all :D

Any one know what the decimal number is for input channel 6 and 6i ???

Title: Re: N2O Input Switch Channel Settings
Post by: Sprocket on August 06, 2009, 06:39:24 PM

BUMP

Doe anyone know?

Decimal or Hex address for the MCP3208 analog input channel numbers 5, 6 and 7

some one must know as there are a few of these settings used ???

Title: Re: N2O Input Switch Channel Settings
Post by: MWfire on August 07, 2009, 01:52:07 AM

i use 1.1.47 and input channel is normal to select(ch 1,2...).
tomorrow i'll loock hex nubmer for channel.

Title: Re: N2O Input Switch Channel Settings
Post by: Sprocket on August 10, 2009, 06:51:27 AM

bumpety bump

:-\

Title: Re: N2O Input Switch Channel Settings
Post by: MWfire on August 17, 2009, 05:07:10 PM

n2o_input = bits , U08, 6, [0:3], "0","1","2","3","4","5","6","7","0inverted","1inverted","2inverted","3inverted","DISABLED","5inverted","6inverted","old: SCL"

VEMS Community Forum

VEMS => Configuration => Topic started by: Sprocket on August 03, 2009, 03:16:24 AM