Quote from: Sambas on November 25, 2008, 01:01:11 PM
Quote from: Arvid on November 25, 2008, 12:06:06 PM
Hi!
Can I use the 1.1.44 with simple trigger? 2 teeth hall trigger, plus hall trigger camsynk? ::)
Did quick test and it should be ok. c004 signal-> coiltype, No. teeth=4, triggertooth=0, another triggertooth=1, toothwheel width=180, secondary trigger=25 and reftooth table=[0,3,2,1]
Thank you! I've Bosch motorsport ignition modules, so I'm not entirely sure how I set up reftooth table. =[0,3] ??? ::)
No. [0,3,2,1] because there is 4 teeth between cam signals.
Repeat desired output in ignition output table twice, something like:
ignition outputs in use 03...00
0
1
0
1
Quote from: GintsK on November 28, 2008, 09:58:02 PM
No. [0,3,2,1] because there is 4 teeth between cam signals.
Repeat desired output in ignition output table twice, something like:
ignition outputs in use 03...00
0
1
0
1
Great! Think I understand a little more now :-) The car started without any problem.