Print Page - Noob - What's the diff between genboard v 3.3 and assembled v3.3 controller

Title: Noob - What's the diff between genboard v 3.3 and assembled v3.3 controller
Post by: ultrasmurf on November 22, 2008, 12:15:27 PM

First post,

As per title, I dont quite get what's the diff ? I'm cheap and 200 euro is a big jump. From the description I just need to solder some FET, IGBT and I get a working EMS ?

I'm planning to FI my KTM EXC400, anyone manage to do FI on a thumper before using VEMS ?

Regards,
Leonard

Title: Re: Noob - What's the diff between genboard v 3.3 and assembled v3.3 controller
Post by: gunni on November 22, 2008, 06:21:13 PM

When all is counted buying everything for a unassembled vems vs. buying a assembled one is very little,
infact the time it will take you to assemble it would be better spent working for the money to pay vems to assemble it.

Title: Re: Noob - What's the diff between genboard v 3.3 and assembled v3.3 controller
Post by: Bat on November 23, 2008, 10:29:32 PM

Hi,
True, but you'll need the PCB plugs, a case, FET clamps, etc. Also the build guide isn't exactly fantastic either!
If I were to do it again I would go ready built every time!
Cheers,
Gavin :)

VEMS Community Forum

General Category => General Discussion => Topic started by: ultrasmurf on November 22, 2008, 12:15:27 PM