HI,
I am experiencing issue similar like misfire but I found that it is "on purpose" ECU by some reason is doing 100% Spark Cut for unknown reason, in random RPM.
I am able to simulate conditions like you have lifted car spinning engine on 5 gear and doing load by brake. It would be considered as low-medium load.
(http://www.vems.hu/files/MembersPage/Matus/Spark%20CUT.png)
Quote from: Matus on May 04, 2018, 11:58:17 AM
HI,
I am experiencing issue similar like misfire but I found that it is "on purpose" ECU by some reason is doing 100% Spark Cut for unknown reason, in random RPM.
I am able to simulate conditions like you have lifted car spinning engine on 5 gear and doing load by brake. It would be considered as low-medium load.
(http://www.vems.hu/files/MembersPage/Matus/Spark%20CUT.png)
do you think, would it be easier to understand what's causing it if you uploaded some log? :D
True :D
http://www.vems.hu/files/MembersPage/Matus/v3.3_u011504-2018.05.01-14.31.11.vemslog (http://www.vems.hu/files/MembersPage/Matus/v3.3_u011504-2018.05.01-14.31.11.vemslog)
Any ideas guys ?
For example I didn't found " spark cut" except REV limiter and Launch control and didn't seen that also within that "calculation" view...
Are reasons/functions for it documented somewhere ?
Quote from: Matus on May 07, 2018, 01:45:43 PM
Any ideas guys ?
For example I didn't found " spark cut" except REV limiter and Launch control and didn't seen that also within that "calculation" view...
Are reasons/functions for it documented somewhere ?
Anti lag(ALS) is on.
Cause has been found.
Anytrim Redline RPM Trim for Lambda target 60% TPS and Lambda target 90% TPS was used. In meaning of engine protection. However it was doing these cuts arround 15% of the TPS so it is not configured as I think.
Quote from: Matus on May 15, 2018, 04:45:47 PM
Cause has been found.
Anytrim Redline RPM Trim for Lambda target 60% TPS and Lambda target 90% TPS was used. In meaning of engine protection. However it was doing these cuts arround 15% of the TPS so it is not configured as I think.
read help file, 60 means not over 60% but bit different :) I would like it to be working different too :)