Print Page - Can bus inforamtion please :)

Title: Can bus inforamtion please :)
Post by: Bat on September 26, 2008, 08:02:55 PM

Hi,
Looking at buying one of these...
http://www.race-technology.com/specification_2_92.html (http://www.race-technology.com/specification_2_92.html)

With a CANbus interface
http://www.race-technology.com/can_interface_2_7534.html (http://www.race-technology.com/can_interface_2_7534.html)

Is the CANbus on the VEMs fully loaded with all the sensor info?
Any CANbus specs, ie standard canbus comms or is it something oddball?
Cheers,
Gavin :)

Title: Re: Can bus inforamtion please :)
Post by: [email protected] on September 30, 2008, 10:27:01 AM

I don't know that VEMS has CAN bus. There was talk of it for the long awaited new hardware.

Title: Re: Can bus inforamtion please :)
Post by: Bat on September 30, 2008, 12:12:34 PM

Hi,
I looked on the wiki there's lots of ideas, but nothing final.
It's labeled up on the board and the pins are connected to a P259 chip....
Cheers
Gavin :)

Title: Re: Can bus inforamtion please :)
Post by: [email protected] on September 30, 2008, 02:57:51 PM

Trouble is that there's WBO2 Two on there too...

Title: Re: Can bus inforamtion please :)
Post by: Bat on September 30, 2008, 07:04:56 PM

Hi,
Think I'd better pass on this one!
Cheers,
Gavin :)

VEMS Community Forum

VEMS => Configuration => Topic started by: Bat on September 26, 2008, 08:02:55 PM