Print Page - Impreza newagde Vems frontplate

Title: Impreza newagde Vems frontplate
Post by: Denmark on September 16, 2008, 09:18:49 PM

I have just made this, for the weekends Vems challenge ;)

(http://img.photobucket.com/albums/v41/Denmark/Vems%20pnp%20Impreza/DSC00826.jpg)
(http://img.photobucket.com/albums/v41/Denmark/Vems%20pnp%20Impreza/DSC00829.jpg)

This is for a bugeye WRX..

/Skassa

Title: Re: Impreza newagde Vems frontplate
Post by: Denmark on September 17, 2008, 08:23:44 PM

And then.. :)

(http://img.photobucket.com/albums/v41/Denmark/Vems%20pnp%20Impreza/DSC00842.jpg)

Title: Re: Impreza newagde Vems frontplate
Post by: gunni on September 18, 2008, 12:37:54 PM

What does the wiring look on the inside?

Title: Re: Impreza newagde Vems frontplate
Post by: Denmark on September 18, 2008, 12:58:38 PM

The Wiring is just made as short as possible, and then it goes to the print, like the Vems AMP connector would have done..
The wires is then glued, when the print is all tested in the car

I will take a pic when i have made the final wires,

/Skassa

Title: Re: Impreza newagde Vems frontplate
Post by: Denmark on October 11, 2008, 05:42:06 PM

this is before the hotmelt

(http://img.photobucket.com/albums/v41/Denmark/Vems%20pnp%20Impreza/DSC00869.jpg)
(http://img.photobucket.com/albums/v41/Denmark/Vems%20pnp%20Impreza/DSC00872.jpg)
(http://img.photobucket.com/albums/v41/Denmark/Vems%20pnp%20Impreza/DSC00870.jpg)

Just another impreza Vems made, going in a car tomorrow :)

/Skassa

VEMS Community Forum

Technical => Wiring & Sensors => Topic started by: Denmark on September 16, 2008, 09:18:49 PM