Hi
I can't seem to get the iac working. It's an bosch duel core t-schape iac without spring. It's installed at pins 6 (fet7 channel 6/64) to open, and (17 fet8 channel 7/128) to close the valve.
So the question is if I should use the injectfet channel 6 or seven in the idle setup. Does the ecu automaticly use channel 7 to close if u pick 6 for the channel? And why are the channels namend 0 to 7 in the idle setup and 1 to 128 in the injector menu? Do you really need the advanced idle setup to make it work?
When I pick channel 6 it seems to not do anything acsept opening in 7 it makes al lot of noise.
The channels correspond to the Injector outputs, so if you select 6 it will correspond to the value in Injector Outputs 6.
So if you set things as here:
(http://www.vems.co.uk/VEMSUserManual/IdleSettings.png)
(Note that the Dual Solenoid option is enabled - you'll need this for the twin solenoid coil).
The Idle controller will use the channel set at Injector output 6 here:
(http://www.vems.co.uk/VEMSUserManual/InjectorOutputs.png)
Which in this case is channel 64 which if you check your pinouts you'll see is EC36-pin6
Because Dual Solenoid is enabled it will by default use the channel defined in Injector output 7, which is set as 128 and corresponds to EC36-pin17.
Oké
Thanx agan.
I didn't realise that the channels should been set in h0 to.