Print Page - Lambda Backwards,

Title: Lambda Backwards,
Post by: Tony C on July 31, 2008, 09:52:23 PM

Hi All,
noticed tonight while tuning the lambda,
that on the grid table, if you move the cursor any where on the lambda grid and lift that point up, it saya richer instead of leaner,
went from 0.99 to 1.07 and it said it was richer,
will this cause any probs?

or is every ones display like this?

Title: Re: Lambda Backwards,
Post by: Stuball on July 31, 2008, 09:54:19 PM

Mine is like this too, raise the lambda and the display says "richer".

Stuball

Title: Re: Lambda Backwards,
Post by: [email protected] on July 31, 2008, 10:19:25 PM

Is this on MegaTune?

Title: Re: Lambda Backwards,
Post by: [email protected] on July 31, 2008, 10:24:01 PM

Just check it you're right, and its wrong.

If you find the vemsv3.ini file and find the entry:
table = lambdaTbl, lambdaMap, "Target Lambda Table",3
   xBins = rpmBinsA, rpm
   yBins = mapBinsA, map
   zBins = lambdaTable
   gridHeight = 1.2
   upDownLabel = "(RICHER)", "(LEANER)"

To:

table = lambdaTbl, lambdaMap, "Target Lambda Table",3
   xBins = rpmBinsA, rpm
   yBins = mapBinsA, map
   zBins = lambdaTable
   gridHeight = 1.2
   upDownLabel = "(LEANER)", "(RICHER)"

Title: Re: Lambda Backwards,
Post by: Tony C on July 31, 2008, 10:39:37 PM

Ta Rob,
:D

VEMS Community Forum

Technical => Wideband & EGT Gauge => Topic started by: Tony C on July 31, 2008, 09:52:23 PM