Print Page - Can you re-calibration the vems to a used wideband sensor?

Title: Can you re-calibration the vems to a used wideband sensor?
Post by: damo_S13 on July 04, 2008, 01:30:14 PM

basicly i have used the Bosch LSU4 sensor i got with my vems once but then updated the softwere which means i need to re-calibrat it right?

Is it ok to do this or do i need to buy a new one?
If i need a new one any one know where i can get it from?

thanks
damo

Title: Re: Can you re-calibration the vems to a used wideband sensor?
Post by: [email protected] on July 04, 2008, 01:42:50 PM

The calibration value is for the sensor, use the old value and you'll be fine.

If you updated the software the original values should still remain.

What version did you update it to?

Rob

Title: Re: Can you re-calibration the vems to a used wideband sensor?
Post by: damo_S13 on July 05, 2008, 07:37:59 AM

its just from when we did it when i got the ecu i will plug in the wideband and see what value i get in free air.

thanks
rob

VEMS Community Forum

VEMS => Calibration & Mapping => Topic started by: damo_S13 on July 04, 2008, 01:30:14 PM