Hi All.
Can any of You clever minds, help mye with a trigger setup config, to use on a Toyota 7AFE engine,
It uses the same setup as the 4AGE setup in this pdf:,
That is all built in to the distributer on the cam,
Were there is a 4 tooth crank(NE signal) and a 1 tooth cam(G1 signal)
I need this for a Celica AT200 94Ã,´
And do i need special firmware?
http://www.autoshop101.com/forms/h23.pdf
Thanks in advance....
Skassa
1.1.18 should be fine.
It will be as noisy as hell, and you'll do well to clamp the G1 signal with a big enough resistor to stop false triggers.
Rob
Thanks Rob,
But itÃ,´s more the trigger settings that i need, iÃ,´m positive that we can filter out the noise,
Thanks,
Skassa
Having tried it I'm not convinced, you might be lucky.
The settings are simple - coil type, 4 teeth in primary trigger, and in secondary trigger type in 25 in the top box and burn to ecu.
Rob
OKay, thanks.
we will give it ago, otherwise there will be a 36-1 wheel on the crank,
as i did on the AE86,
ItÃ,´s just that we are a bit in a hurry, as this Toyota also will be attemting the 3days at the Ring, the 3th - 6th may,
So a bit short on time, to get everything back together, and get it running.
Thanks,
Skassa