Print Page - Adding 2nd EGT to assembled VEMS

Title: Adding 2nd EGT to assembled VEMS
Post by: MTRacing on March 23, 2008, 04:19:03 PM

I inadvertantly ordered my pre-assembled VEMS configured with only one EGT on-board and would like to have two. :(

Is this as simple as adding a second AD597AR chip or are other parts needed? I already have two thermocouples.

Any guidance out there regarding the steps to add the second before I dig into this?

Thanks!

Mike

Title: Re: Adding 2nd EGT to assembled VEMS
Post by: [email protected] on March 23, 2008, 05:32:29 PM

IIRC the AD597AR has two inputs, so its down to getting the second channel connected with k-type wire.

Title: Re: Adding 2nd EGT to assembled VEMS
Post by: gunni on March 23, 2008, 07:19:32 PM

According to the build sheet you install another chip on the flip side,

VEMS Community Forum

Technical => Wideband & EGT Gauge => Topic started by: MTRacing on March 23, 2008, 04:19:03 PM