Hi folks. I have setup my primary VR and secondary HALL sensor, and i have the following triggerlog. I believe the signals are ok, but still, the ignition outputs seem of.
If you could point me in the right direction for getting the correct spark timing, i would be very gratefull! :)
http://i954.photobucket.com/albums/ae26/christiancdk/Primary%20trigger_zps0p8yfkbf.png~original
This is my trigger settings, TDC after trigger is at 78 now.
(http://i954.photobucket.com/albums/ae26/christiancdk/Visiual_zpsgvccxpjv.png)
Ignitions settings as follows:
(http://i954.photobucket.com/albums/ae26/christiancdk/Tnding_zpsztieow4b.png)
What do you mean by seems of?
Can you produce a triggerlog and a vemslog of the engine cranking or running?
Hi gunni
I have the following triggerlog:
(http://billeder.bazoom.dk/biler/album/468/xl/2335622/audi-b5.jpg)
When i say it seems off, i mean that there are only one ignition/spark per 360 rotation, maybe even less. There should be 2 (im not running wasted spark) I have changed the TDC after trigger to 78 since this log was made, i might try 54 degrees (13-4 teeth, 6 degrees apart).
The engine is only cranking, not starting on this log.
The rest of the setup:
(http://billeder.bazoom.dk/biler/album/468/xl/2335625/audi-b5.jpg)
(http://billeder.bazoom.dk/biler/album/468/xl/2335621/audi-b5.jpg)
(http://billeder.bazoom.dk/biler/album/468/xl/2335623/audi-b5.jpg)
(http://billeder.bazoom.dk/biler/album/468/xl/2335624/audi-b5.jpg)
I could not get this sequiental firing to work, so i'm running without cam-sync now, and just using 2 stepper outputs, thereby running wasted spark setup, and it works like a charm now.