Hello,
why is the exhaust gas regulation not working - EGT regulation is set to 984 deg. Calculation table is showing the right calculation (lambda -0.1 and boost - 7kPa but ECU values do not change. So no effect :o
(http://fs5.directupload.net/images/170921/7rvtx4em.jpg) (http://www.directupload.net)
dont see your boost target :)
Quote from: Kamuto on September 21, 2017, 05:55:03 PM
dont see your boost target :)
I can scroll to the right ( "boost target curve (RPM,GEAR) = 298 kPa - dont you? :) but I show you the curve ;-) thanks
(http://fs5.directupload.net/images/170922/pcxluz46.jpg) (http://www.directupload.net)
ok, maybe find some spot where it's not over 5 degrees... because that vt values, not ecu. it should be working properly and 200% it is working as it should.
(from where does one get this "Boost target 1st gear window" :P??)
Quote from: fphil on September 23, 2017, 07:40:39 PM
(from where does one get this "Boost target 1st gear window" :P??)
when you are using 3 year old fw you can find even more interesting things
I found interesting thinks in every firmware I tested :P
After lowering threshold to 960 deg - its clearly working now. Thanks.