Text only | Text with Images

VEMS Community Forum

VEMS => Software => Topic started by: RazOn on February 05, 2017, 09:00:09 AM

Title: WOT - shift cut time set to 1020 issues
Post by: RazOn on February 05, 2017, 09:00:09 AM
I have a sequential gearbox that has output signal to reduce torque for gear change. It removes the signal one the shift is complete.
I set the shift cut time to 1020 so that power will be cut for as long as the transmission needs to change the gear.
However, I noticed that after transmission removes the signal, VEMS still cuts spark in my case for another ~100ms. This makes for very slow shifting (relatively speaking).

Anybody know how to make it better?
Title: Re: WOT - shift cut time set to 1020 issues
Post by: RazOn on February 07, 2017, 05:29:32 AM
New firmware fixed it!
Title: Re: WOT - shift cut time set to 1020 issues
Post by: Kamuto on February 07, 2017, 11:41:17 AM
Quote from: RazOn on February 07, 2017, 05:29:32 AM
New firmware fixed it!
good to hear :)
Title: Re: WOT - shift cut time set to 1020 issues
Post by: Morty on October 03, 2022, 05:41:20 PM
I have the same issue on firmware 1.2.38. Which firmware version should I go for. A local VEMS dealer updated to this and said it was the one he recommended.
Text only | Text with Images