Text only | Text with Images

VEMS Community Forum

Technical => Wiring & Sensors => Topic started by: miniminor63 on November 01, 2007, 05:17:32 PM

Title: quicky: how to remove pin
Post by: miniminor63 on November 01, 2007, 05:17:32 PM
Hi

I put a pin into the wrong slot in my econoseal 36. How do I get it out again without breaking anything?

Thanks
Title: Re: quicky: how to remove pin
Post by: hilly on November 01, 2007, 07:50:17 PM
There is a little barb (part of the black plastic of the Eccon connector) which engages as the metal contact is pushed in and holds the wire in place.

You need to insert a small flat blade screw driver from the from the front of the connector, lift up the barb and then pull the wire out from the back, dead simple :)

Hilly
Title: Re: quicky: how to remove pin
Post by: lost on April 16, 2010, 02:31:51 AM
(http://img690.imageshack.us/img690/9349/ecu36195.jpg) (http://img690.imageshack.us/i/ecu36195.jpg/)

White plastic cover wont go in econoseal, it sticks out 2mm, on ec18 it fits without problem.

Any ideas before i pull every ec36 wire out  ::)
Title: Re: quicky: how to remove pin
Post by: lugnuts on April 16, 2010, 08:05:24 AM
you have the wire end pushed in too far in the terminal, try not to go much past the metal crimp area
Title: Re: quicky: how to remove pin
Post by: lost on April 16, 2010, 08:56:53 AM
 :-\ :'( :'( :'(

Thanks
Title: Re: quicky: how to remove pin
Post by: [email protected] on April 16, 2010, 04:37:10 PM
I wrote something about pin removal here:
http://www.vems.co.uk/VEMSSchematics/1+2JZLoomGuide07May2008.pdf
Text only | Text with Images