VEMS Community Forum

General Category => General Discussion => Topic started by: Matus on October 26, 2015, 03:41:29 PM

Title: Use analog input in condition >> Protection
Post by: Matus on October 26, 2015, 03:41:29 PM
Hi,

Is it possible to configure analog input as condition trigger for protection like ? : condition pressure below value   action turn of ignition or / RPM limit set to 2000

I would like to simulate Stock protections like i seen in  M3 E92 where oil temperature above 140st cause  change of allowed RPM

Title: Re: Use analog input in condition >> Protection
Post by: Kamuto on October 27, 2015, 01:01:22 AM
Quote from: Matus on October 26, 2015, 03:41:29 PM
Hi,

Is it possible to configure analog input as condition trigger for protection like ? : condition pressure below value   action turn of ignition or / RPM limit set to 2000

I would like to simulate Stock protections like i seen in  M3 E92 where oil temperature above 140st cause  change of allowed RPM
yes, no problem, use anytrim channels :)
Title: Re: Use analog input in condition >> Protection
Post by: Matus on October 28, 2015, 06:05:43 PM
Nice, I found it finally regarding name of the feature. Thanks.

Actually I found also help page for it but I don't see how to have available all five channels as I see only CH1 - CH3. Also available options that I see don't match with options listed in help.
So the question is .. is it version depending ( yes I suppose ) and how I can "activate" other channels ?

I am using VemsTune 1.5.33

ECU is running firmware1.2.31
Title: Re: Use analog input in condition >> Protection
Post by: Kamuto on October 28, 2015, 11:37:22 PM
Quote from: Matus on October 28, 2015, 06:05:43 PM
Nice, I found it finally regarding name of the feature. Thanks.

Actually I found also help page for it but I don't see how to have available all five channels as I see only CH1 - CH3. Also available options that I see don't match with options listed in help.
So the question is .. is it version depending ( yes I suppose ) and how I can "activate" other channels ?

I am using VemsTune 1.5.33

ECU is running firmware1.2.31
upgrade it to 1.2.32 :) it has much more options for anytrim :)
Title: Re: Use analog input in condition >> Protection
Post by: Matus on October 30, 2015, 09:39:53 AM
And how to upgrade to 1.2.32 when I don't see it as available from web ?
I just have example config file version 1.2.32 where I see all 5 Anytrim channels
Title: Re: Use analog input in condition >> Protection
Post by: Matus on February 08, 2016, 02:24:50 PM
Hi,

Any news ? I start working on new cabling finally actually car cabling in first. It takes me up to 3 weeks  and than I would like to start with engine cabling. So this topic is starting to be important for me :D

(https://scontent-dfw1-1.xx.fbcdn.net/hphotos-xpl1/v/t35.0-12/12695527_10208523238426397_263147600_o.jpg?oh=0b1c44f9199cb6d907c32e346cb89a97&oe=56BAE1CC)