Print Page - Missing channels in AIM protocol

Title: Missing channels in AIM protocol
Post by: jm motorsport on October 24, 2015, 11:38:56 AM

Did a litte project to try go get the data from VEMS using the AIM protocol. I get the data but there seem to be channels missing

For example, the following channels are not sent:

Channel: 9 - Oil pressure
Channel: 13 - Oil temp
Channel: 109 - Fuel temp

Any ideas?

Link to the AIM/VEMS document:
http://www.vems.hu/files/MembersPage/NanassyPeter/AIM_support/AIM-ECU%20protocol.pdf

Title: Re: Missing channels in AIM protocol
Post by: VEMS on October 24, 2015, 12:00:45 PM

Correct these channels are currently not send.

Best regards, Dave

Title: Re: Missing channels in AIM protocol
Post by: jm motorsport on October 24, 2015, 01:37:28 PM

Any info if or when this will be available.? I guess it would be possible to use the fuel pressure channel for oil pressure, but oil temp is pretty vital for me as well. Hate to have to switch ECU >:(

VEMS Community Forum

General Category => General Discussion => Topic started by: jm motorsport on October 24, 2015, 11:38:56 AM