Print Page - HC-05/06 on ISPI port?

Title: HC-05/06 on ISPI port?
Post by: behindthewheel on October 22, 2015, 10:27:16 PM

Hello all,

I read somewhere a fellow member has successfully used an Arduino HC05/06 on the ISPI port. I've been searching all around & it sounds doable. It will be great if it can be done. I will actually 'freevthe serial port connection on EC18, less wires, more flexibility 8)

Title: Re: HC-05/06 on ISPI port?
Post by: mads b (dk) on October 23, 2015, 06:55:13 PM

Look here
http://www.vemssupport.com/forum/index.php/topic,1740.165.html

Title: Re: HC-05/06 on ISPI port?
Post by: behindthewheel on October 23, 2015, 11:18:32 PM

Actually that's the post I was referring to which gave me the idea. ;D
I am a little bit skeptic, so more details will be appreciated.
I am going to try that in all cases. Fingers crossed ;D

Title: Re: HC-05/06 on ISPI port?
Post by: mads b (dk) on October 24, 2015, 07:29:11 AM

I'm running my hc06 like that

Title: Re: HC-05/06 on ISPI port?
Post by: behindthewheel on October 28, 2015, 12:32:52 PM

Did it just work right away? Just wired Vcc,GND, Tx, Rx and worked?
Does the board provide the Vcc or did you power it from an external source?
I am going to open it up by next weekend and hook it up

Title: Re: HC-05/06 on ISPI port?
Post by: mads b (dk) on October 28, 2015, 04:01:17 PM

You have to setup baud rate on hc06 before it will work with vems

VEMS Community Forum

VEMS => Software => Topic started by: behindthewheel on October 22, 2015, 10:27:16 PM