Print Page - Wiring Shift cut input(ground) to EC18-8

Title: Wiring Shift cut input(ground) to EC18-8
Post by: jdm ej1 95 on October 17, 2015, 12:14:56 AM

Can i use this input as my shift cut input. its my only one left with pullup and protection.

labeled as wheel speed on my spec sheet.

Title: Re: Wiring Shift cut input(ground) to EC18-8
Post by: VEMS on October 17, 2015, 08:34:11 AM

Hello Jdm ej1 95,

No, wheelspeed input cannot be used as shiftcut input.

Best regards, Dave

Title: Re: Wiring Shift cut input(ground) to EC18-8
Post by: jdm ej1 95 on October 24, 2015, 12:43:52 AM

is protection a necessity when wiring a ground trigger to the pullup?

VEMS Community Forum