Print Page - Mcp3208 probably fried, but why?

Title: Mcp3208 probably fried, but why?
Post by: Razkin on August 03, 2015, 03:25:55 PM

(http://i.imgur.com/tHLztSD.png)

I installed a fuel pressure like in the above picture. The 5V is supplied bij VEMS 5V output(EC36 28). It worked fine for a couple of hours, but somehow something has gone wrong and the value fluctuates a lot and so is the EGT input.

Is the way I installed the sensor the cause of the malfunction and if so what have I done wrong?

Title: Re: Mcp3208 probably fried, but why?
Post by: MWfire on August 04, 2015, 10:46:09 AM

Did you use sensor ground? If not, that is a problem. You fried mcp during cranking.

Title: Re: Mcp3208 probably fried, but why?
Post by: Razkin on August 04, 2015, 11:13:09 AM

Yes, sensor ground was used.

VEMS Community Forum

Technical => Wiring & Sensors => Topic started by: Razkin on August 03, 2015, 03:25:55 PM