Text only | Text with Images

VEMS Community Forum

Technical => Wideband & EGT Gauge => Topic started by: gunni on February 02, 2015, 07:35:40 PM

Title: Problem with V3 data, only peak values shown.
Post by: gunni on February 02, 2015, 07:35:40 PM
I'm using 1.2.30 on the ECU and latest round code and running AIM protocol.

Whatever is the peak value from the ECU will stay on the round until everything is powered off, anybody seen this before?
Title: Re: Problem with V3 data, only peak values shown.
Post by: VEMS on February 09, 2015, 06:41:09 PM
Hello Gunni,

Most likely peak-hold mode is active on some (or all) of the slots, see: http://vems.hu/vt/help/round/round_display_peak_hold_settings.html

Best regards, Dave
Title: Re: Problem with V3 data, only peak values shown.
Post by: gunni on February 10, 2015, 09:41:57 PM
This doesn´t come up as an option

I´m using VT 1.5.29
Title: Re: Problem with V3 data, only peak values shown.
Post by: VEMS on February 17, 2015, 09:10:28 AM
What firmware version are you running in your round ?

Title: Re: Problem with V3 data, only peak values shown.
Post by: gunni on February 17, 2015, 01:06:53 PM
It was the latest available for AIM
Title: Re: Problem with V3 data, only peak values shown.
Post by: VEMS on February 18, 2015, 10:34:44 AM
That would be 0.5.8 firmware, please confirm. Make sure to run ini update from VemsTune -> Preferences -> Update ini files from web to update your Vemstune installation with ini files matching the newer firmwares. After that the option should be available in Display -> Display Peak Hold Setting.

Best regards, Dave
Title: Re: Problem with V3 data, only peak values shown.
Post by: Wolf_Tm on March 18, 2015, 08:40:09 PM
Same happened to me:

http://www.vemssupport.com/forum/index.php/topic,2338.0.html
Text only | Text with Images