Engine had been running for the best part of two years without trigger errors that I am aware of.
In the last couple of weeks I have installed a second trigger and wiring.... unfortunately I am now getting primary trigger errors, vems log and trigger log:
http://vems.hu/vemstune/sharingcenter/reports.php?cmd=view&key=YoyaXv
(http://i1337.photobucket.com/albums/o675/se7ensport1/camsynctriggerlog_zps9a2350ff.png) (http://s1337.photobucket.com/user/se7ensport1/media/camsynctriggerlog_zps9a2350ff.png.html)
Rolling back to primary only still gives errors and is almost impossible to start:
http://vems.hu/vemstune/sharingcenter/reports.php?cmd=view&key=kYcQrp
(http://i1337.photobucket.com/albums/o675/se7ensport1/primaryonlytriggerlog_zps0cdcf7fd.png) (http://s1337.photobucket.com/user/se7ensport1/media/primaryonlytriggerlog_zps0cdcf7fd.png.html)
Before I rip out the existing wiring, plug and sensor to run a new set is there anything the logs hint at as I'm working on the basis that it must be a bloody coincidence that I likely disturbed a dodgy connection while adding the cam sensor or the crank sensor has just decided to pack up.
EDIT: VR sensors for both Cam (pin 1 to EC36-13 and pin 2 + shield to earth) and Crank (pin 1 to EC36-27 and pin 2 + shield to earth).