I'm a little confused regarding high / standard boost profile settings. I was under the impression this was directly related to how the firmware was compiled?
also how is the kpa unit different than the map sensor range?
i think i'm overthinking these settings and getting myself in trouble with a firmware upgrade :(
thanks.
Its not firmware related, but depending on your choice of Table kPa unit, if you've gone for a 400kpa sensor you'll have selected 2 (high boost) and you'll want the High Boost profile. We have this because high boost needs to scale its pressure readings differently to the lowboost.
Quote from: [email protected] on August 28, 2007, 08:12:50 PM
Its not firmware related, but depending on your choice of Table kPa unit, if you've gone for a 400kpa sensor you'll have selected 2 (high boost) and you'll want the High Boost profile. We have this because high boost needs to scale its pressure readings differently to the lowboost.
Hi, a little bit outdated topic, but anyway.... If I want to use the 300kPa sensor from VEMS shop (5V supply voltage, 300 kPa), what should I do ?
FW 1.0.78RC2.
Thansk. Pet
Use the Highboost option and set Settings->Basic Settings MAP Sensor range (kPa) to 300