Hi, please, I am a bit confused from anytrim settings;
1] boost:
I'd like to use anytrim for boost target change. Example: when I lower boost target from 250kPa to 180kPa (spring is 160kPa) via anytrim, boost refDC table remains unchanged (or vice versa; I lower refDC via anytrim but boost target remains unchanged). How about PID regulation then ? Will it work ?
2] launch:
The same for launch settings. Is it possible to change launch curve via anytrim or it will change only static launch RPM ?? (As input for anytrim wheelspeed1 or AD1-7 ?)
Thanks.
With the new boost control this target changing will be easy.
You essentially set a fixed target and then tune the DCref for that boost pressure only, then move up a row and do the same, then when the DCref table is fully mapped to the highest boost you will go to you can set up a anytrim boost additive function so that min = 0 added and max = XXXkpa added to the target.
Thank you Gunni once again !!! I've got it - Reference lookup - Boost target base :) Anyway, is this table correct ? (it's only example of course ). Thanks a lot.
(http://ww.mervart.eu/!projects/VEMS_astra_t3/foto/1.2.11_refdc_boost_table_init.PNG)
Yes that looks fine.
So if you use 260 kpa as boosttarget, the reference will be 40%.
When raising it 40kpa with anytrim, the reference will be 50%.