Print Page - Missing tooth primary trigger on camshaft

Title: Missing tooth primary trigger on camshaft
Post by: Cornelius on November 28, 2012, 10:22:33 PM

Need help to configure 48-2 prim.trigger on camshaft,Angular Width Of Tooth=15 crankdegrees.Engine is 1 cyl. 4-stroke , 1 event every 48 teeth.Can vems handle such trigger?

Title: Re: Missing tooth primary trigger on camshaft
Post by: GintsK on November 29, 2012, 07:10:22 AM

I think it should. Your settings seems correct. Ref tooth table may consist from one 0.
Then you can capture trigger log where you'll see where the power stroke TDC is - slowest sector along one cycle.

Gints

Title: Re: Missing tooth primary trigger on camshaft
Post by: Cornelius on November 29, 2012, 08:45:24 AM

I've made some bench tests, everything seems to work fine , but I am worrying about the errors on the pri.trigger setting menu ::). should I ignore them?

Title: Re: Missing tooth primary trigger on camshaft
Post by: GintsK on November 29, 2012, 09:47:01 AM

I think you can ignore them. If your triggerlog seems correct.

1.2.x firmware gives also spark and triggering error events in triggerlog. Did you tried?

VEMS Community Forum

Technical => Triggering => Topic started by: Cornelius on November 28, 2012, 10:22:33 PM