Hello. I have put a vems on my peugeot 306 2.0 16v and keep many of the same settings that I had on my old peugeot 205 2.0 8v. but the new car running with a stepper instead of a acuacot. and I do not know how to get it to work. it is connected in the sense that the EC 18 is set to pin10 two A pin11 two B pin 5 to C pin 4 to D ..
but how should the control of mega tune I run with the old version 1.0.53
hope to have someone who can help me.
regards dennis
Quote from: 306 2.0 16v on October 04, 2012, 02:30:10 PM
Hello. I have put a vems on my peugeot 306 2.0 16v and keep many of the same settings that I had on my old peugeot 205 2.0 8v. but the new car running with a stepper instead of a acuacot. and I do not know how to get it to work. it is connected in the sense that the EC 18 is set to pin10 two A pin11 two B pin 5 to C pin 4 to D ..
but how should the control of mega tune I run with the old version 1.0.53
hope to have someone who can help me.
regards dennis
download vemstune + use newer firmware. http://vems.hu/download/v3gui/NIGHTLY/
Thanks for your reply. It seems to idle works now.
so now all I need to get the engine to take rpm. it will only go up in rpm when it reaches 50% throttle.
thanks dennis
It´s best to post a log and config.
you can even do that from within Vemstune, which you should be usinga and post the link to here.