Trying to start the engine when the engine turns slows as if the explosion occurs at the wrong time.
Then verify with Vemstune and watch the sparks jumping simultaneously the four, no 1 & 4 and 2 & 3, but 1 & 2 & 3 & 4 all the time.
I try again to start the engine and then it sparks fly inside the cylinders. >:(
I returned to check the coil, wires, and the test with Vemstune, with the sparks fly test, the four simultaneously.
The firmware is 1.1.95.
The serial number 868.
I do not know if it's a configuration problem.
I would appreciate your help.
You're using a wasted spark coil pack?
It appears that you have both ignition channels firing at once - do you have dual ignition out on by mistake?
If dual out is not set,
Can you try another ignition channel?
Or can you unset one of the ignition channels so that you can make sure that its not a wiring issue?
The problem of simultaneous sparks was because they had installed a shift ligt and badly configured or badly.
Once I solved this problem and reloaded the latest firmware and everything works properly.
Thanks for everything.
Chencho 1600.
Care should be taken with additional devices! ;)
Good to know that it is working again now.
It is a shame that the tuning software does not have a single screen that allows features to be turned on and off. It would make fault finding a little easier.