Hi,
I have the usual ADU (AAN) PnP VEMS with the following extra connectors
pin1 mcp3208 pin6,ch5
pin2 mcp3208 pin7,ch6
pin3 mcp3208 pin8,ch7
pin4 EC36 pin 34 (power out)
pin5 EC36 pin 36 (power out)
pin6 GND
Can I connect a solenoid there that I can control on a 3D map with MAP/RPM/DC? I already have a WGFV but I need an extra for WI solenoid control.
thanks
Yes.
Boost Control -> Secondary PWM
ok, but at what PIN on the connector?
Pin 4 or 5, if that's not obvious. Those are ignition drivers (IGBT) and can handle a lot. http://www.vemssupport.com/forum/index.php/topic,1266.0.html
The word power out is obvius but does not answer all. What do I choose in Secondary PWD settings: SPECFET, I259 or what?
my vems is PnP serial 1441. the outputs are the same?
Quote from: billman on November 29, 2011, 10:46:37 PM
What do I choose in Secondary PWD settings: SPECFET, I259 or what?
pin4 EC36 pin 34 (power out) == I259 channel 2
pin5 EC36 pin 36 (power out) == I259 channel 3
It's not been made easy on all menus yet (this is one example) but if you go to "Ignition Outputs Visual" you can trace pin number to channel number. I259 is the ignition driver.
"assign output channels" also give help. It is much more easier these days than couple years before.
Then you had to keep this schedule always at hand:
http://www.vems.hu/wiki/index.php?page=GenBoard%2FManual%2FDigitalOut%2FTable
Nice, thanks guys!