Print Page - Less Pr.trig

Title: Less Pr.trig
Post by: utkuselamoglu on October 17, 2011, 04:24:50 PM

I am having this error (â€¢Less Pr.trig: less primary trigger detected than it should be )
after revving my engine over 5500 rpm and the error stays there. but the car runs great to the rev limiter 7200 rpm.
do you think Ä± can drive with having less trigger error or It shouldnT be there while running the engine.

Title: Re: Less Pr.trig
Post by: utkuselamoglu on October 19, 2011, 07:25:18 AM

I have mesured the resistance of the sensor it gives 500 ohms instead of 800. In datasheet it show 800 ohm..

Title: Re: Less Pr.trig
Post by: [email protected] on October 20, 2011, 02:12:30 PM

Perhaps it might help if you tell us what the engine is.

Title: Re: Less Pr.trig
Post by: utkuselamoglu on October 21, 2011, 08:04:21 AM

Hi Rob,

The car is Audi A4 1997 1.8t FWD
The engine code is AEB.

Thank you.

Title: Re: Less Pr.trig
Post by: mattias on October 21, 2011, 11:19:24 AM

These days it's more than easy to publish a datalog of your problem. See the Help menu and error reporting tool, provide the web link and you hopefully get more second opinions.

I suspect it may just be because of behaviour of your particular firmware and the settings you have. It's a bit silly to expect answers and not provide this basic information.

Title: Re: Less Pr.trig
Post by: utkuselamoglu on October 30, 2011, 09:05:31 AM

Hi I have changed my crankshaft position sensor with the new one and the problem solved.

Thanks alot.

VEMS Community Forum

Technical => Triggering => Topic started by: utkuselamoglu on October 17, 2011, 04:24:50 PM